Assembly Instructions: 3281-BA1 BI (Moreno)
IMPORTANT:
• ALL INSTALLATION WORK SHOULD BE DONE BY ACCREDITED PROFESSIONAL.
• SHUT OFF POWER SUPPLY AT FUSE OR CIRCUIT BREAKER!
• USE ONLY THE SPECIFIED BULBS. DO NOT EXCEED THE MAXIMUM WATTAGE!
PREPARING FOR INSTALLATION
Carefully remove all of the contents from the carton. See
the important notes above. Shut off the power at the circuit
breakerandcompletelyremovetheoldxturefromthewall,
including the old mounting strap.
From the parts bag remove the mounting strap assembly. One
end of nipple (A) should be attached to mounting strap (B).
You may need to tighten the nut that holds this in place. Place
mountingstrap(B)overthejunctionboxsothatnipple(A)is
horizontal.Securemountingstrap(B)tothejunctionboxwith
mounting screws (D) and a screwdriver. Tighten the screws
securely.
CONNECTING THE WIRES
Attachthexture’swirestothepowersupplywiresfromthe
junctionbox.Connectblacktoblack(orsmooth);whiteto
white(orribbed);groundtoground(greenorcopper).Twistthe
endsofthewirepairstogether,thentwistonawireconnector.
Make sure all twists are in the same direction. If there is no
groundwire(greenorcopper)fromthejunctionbox,locate
groundscrew(E)onmountingstrap(B)andwrapthexture
ground wire around the green ground screw (E). Use a
screwdriver to secure ground screw (E) onto the mounting
bracket.Tuckallwiresneatlyintothejunctionbox.
FINISHING THE INSTALLATION
Placexturebackplate(C)overnipple(A)sothatitprotrudes
through the hole in the front of the backplate. Thread
decorative nut (G) onto nipple (A). Twist the decorative nut until
thebackplateofthextureissnugagainstthewall.
Slide glass shade (H) over the socket. Place rubber washer (M)
andgasket(L)overthesocketandsecuretheglass,washer
and gasket in place by using socket tool (K) to tighten socket
ring (I) onto socket (F).
Install the provided halogen bulb. See the bulb note below.
Bulb Note: Use a tissue or paper towel to hold the bulb and
pushdownintothesocket.Oilsordirtcancausethebulb’s
lifetoshorten.Ifdirty,rubbingalcoholisrecommendedfor
cleaning the bulbs.
Your installation is now complete. Turn on the power and test
thexture.
CLEANING TIPS
Treat the xture gently! Regular cleaning will reduce the need for deep cleaning. For regular cleaning, turn off the light and wipe down
the xture with a clean lint-free cotton or microber cloth. Never spray cleaner directly onto the xture. For deep cleaning, turn off the
light and remove the glass prior to cleaning. Place the glass shades aside to clean one at a time. Hand wash glass with warm water
and mild detergent. Dry with a lint-free or microber cloth.
For Customer Service, contact
the place of purchase to arrange
for replacement parts.
A
C
G
E
B
F
D
H
K
I
J
M
L
Komentarze do niniejszej Instrukcji